Why Peugeot 308 Key Fob Isn't A Topic That People Are Interested In.
www.g28carkeys.co.uk might be catching on a bit but it's still attractive. It's not the most luxurious car in its class but it's a Ford Focus or Volkswagen Golf will help you stay away from surface imperfections - but it's a relaxing and comfortable drive.
We are often asked at Coded Car Keys to replace peugeot key fobs. Whether the problem is intermittent or constant the following tips will assist.
Water Damage
When you accidentally leave your fob in the midst of a puddle or get it wet while kayaking, swimming canoeing, rafting, or canyoning, it's more likely to suffer water damage. Keep your key fob in a dry container whenever you go outdoors or do activities that expose it to excessive water.
It's also crucial to make sure that the fob is completely dried before you open it and use it again. If you smell any odors from the fob (such as industrial fluid or windshield washer fluid) It's another indication that it's submerged.
A wet circuit could cause the battery's power to be depleted or even explode. If you can pull the 308 keyfob from the water you need to turn the button side up and shake as much water out as you can prior to opening the casing. After you open it, remove the battery and clean the circuit board with the help of a cotton swab that has been dipped in 90 percent isopropyl alcohol.
Other reasons why your Peugeot 308 remote keyless entry system may fail to function include the battery of your coin is dead or receiver module issue, signal interference, or an electronic chip malfunctioning. If none of these are the cause, you can try resetting the system by disconnection of the battery at 12 volts for about 15 minutes.
Dead Coin Battery
Peugeot cars are equipped with a remote-start system which allows the driver to start the car from afar by warming up or cooling down the vehicle prior to getting in. This feature is extremely beneficial, especially during cold winter months. However, sometimes the remote start system stops functioning due to a variety of reasons, like the battery of a coin that is dead.
A coin-shaped battery that is located inside the key fob has a life span of between two and four years, based on how often it's used and where it's purchased. The use-by date will be displayed on the packaging or in the user manual.
If the key fob has stopped working after exposure to water that is clean, you should remove the battery, clean the electronic chip using a paper towel and isopropyl alcohol, and then dry it thoroughly before replacing it. If exposed to soapy or salty water, the chip might be damaged and you'll have to replace the key fob completely.
If you're unsure if the battery is defective it is possible to test the voltage with a multimeter set to your vehicle's voltage range and connected to the plus and minus terminals. The voltage should read approximately 12 to 13 volts, but if it's lower, the battery should be replaced. You can also reset the computer onboard by disconnecting and reconnecting the 12 volt batteries in reverse order. (positive cable first then negative cable). The engine should now start.
Faulty Receiver Module
If you don't get the "Key Detected" It could be the receiver module malfunctioning. It's the part that sends an alarm to the car when the key fob is activated which also acts as an immobiliser. It stops it from starting until the correct key is in place.
This could be caused by a number of causes, such as water damage or just the aging process. If the chip inside your Peugeot 308 keyfob has been damaged due to dirty tap water, it could be because the keyfob was in contact with it. In this instance it is necessary to take it apart and clean it thoroughly using isopropyl alcohol, or electronic cleaner. When the battery is dry you can try it again.
If the issue persists, it's probably a good idea to seek out a local Peugeot specialist or locksmith. They'll be able employ a diagnostic tool assist in identifying the problem and repair it for you.
The loss of your Peugeot keys to your car is a stressful experience. However, a reputable auto locksmith can resolve the issue in just a few minutes. They can cut a brand new key and programme it to your vehicle, ensuring that you're back to the road as fast as you can. Click here to find a locksmith near you.
Electronic chip that is malfunctioning
The electronic chip in the Peugeot 308 key fob is a very crucial component of the remote control system. If the chip is damaged, you may experience difficulties starting your vehicle or receive a message saying "anti-theft". In this instance, the only solution is to replace the key. Auto locksmiths with experience are able to provide the service within the shortest possible time.
The chip inside the chip of your Peugeot 308 key fob can be damaged by water damage, sweat dirt, or other reasons. If your Peugeot key fob was exposed to soapy or dirty water, it should be cleaned as soon as possible. You can make use of a towel and isopropyl alcohol to clean the electronic component. The battery should be allowed to fully dry.
Sometimes the key fob may not function due to radio interference. This can happen when other devices operate on the same frequency as your Peugeot keyfob. It could be caused by bad conditions or objects close to the vehicle. If you experience this problem you should visit an Peugeot dealership.
The Peugeot 207/308 Key Fob is delicate and requires special attention. It is crucial not to drop or throw the key fob. If you lose something, try to locate it as soon as possible. You can reset the onboard computer by disconnecting the battery for a few minutes. Make sure you disconnect the negative cable first before connecting the positive.